Mini Power Distribution Board PCB for QAV250 CC3D Flight Controller with 5V 12V

Product Description

Mini Power Distribution Board PCB for QAV250 CC3D Flight Controller with 5V 12V

Latest cc3d dedicated sub-panel
 
With two bec output 5v and 12v voltage input 2-6s with the shield case
 
The latest upgrade current output reaches 3a
 
A metal shield case to minimize signal interference
 
 cc3d distributor plate with two bec output 5v and 12v
 
Holes and dimensions cc3d flight control board exactly the same
 
Input voltage 2-6s
 
12v bec require input power at least 4s, 3s, such as it is not necessary to use a bec
 
This sub-panels using the industry’s highest standard industrial ti chip, and the pcb board to do a fully optimized, thicker copper increased stability with the shield cover.
 
Dc-dc power supply itself is high-frequency switching state, when the work itself back to produce a high-frequency interference sources, plus the distance and flight control sub-plate between the plates is very close, as well as other accessories, as pass receiver remote control these data transmission and other radio equipment, the frequency is not the same as each other will lead to mutual interference, plus rear shield cover, completely remove power to the remote control receiver of FIG pass interference, but also aircraft a clean, stable power supply. Choose a good power supply can be reduced or even completely eliminate the possibility of power because of the flight control interference caused the bombing.